circumcision stapler
Nowadays, many circumcision surgeries use this type of disposable stapler. The main reason is that the trauma is smaller and the repair is faster. It has advantages over traditional surgical methods and the wound is much more beautiful. So how effective is the circumcision stapler? What surgical treatments are available?
Surgical treatment work experience and methods:
1. After placing the bell-shaped penis glans seat into the foreskin, gently press the penis frenulum twice with your right index finger, push the glans of the penis into the bell jar, ensure that the penis frenulum is loose, and then tie the foreskin firmly on the support rod.
2. When using this device for the first time, if the circumcision position is indeed almost the same, you can draw a circle around the location where it is expected to be cut before putting it into the glans penis seat (this circle is the circumcision position), and then draw another circle about 1.5-2mm inside the circle (this circle is placed in the glans glans seat and can be seen on both sides of the device head when the device is installed, because the circumcision position cannot be seen after the device is installed).
3. In case of children or children whose foreskin is too long or too thick, cut off the overlong foreskin outside the tie and then put on the equipment. This will help to better cut the seam.
4. After cutting, loosen the adjusting knob and move it back more than 5mm. Maintain the position and do not move too much. Push the adjusting knob forward to release the bell-shaped glans base. If it is not easy to push, you can lightly touch the rocker (do not repeat the operation if possible) ) Loosen the cutting suture position (in front of the suture device). At this time, observe whether the foreskin is completely disconnected and the foreskin is too long. If it is completely disconnected, gently rotate and remove the device. If there is still a small amount that is not disconnected, you can use scissors or a knife head to trim it slightly and then remove the device. Sometimes the knife head is pulled out a small part by the anvil, which has no effect on the surgical treatment.
5. After removing the equipment (do not waste time observing), immediately wrap the wound with dry gauze and apply moderate pressure to activate blood circulation for about 5 minutes. If there is bleeding after loosening (rarely), you can add stitches to activate blood circulation, otherwise apply moderate pressure bandage as usual.
6. It is recommended to use a self-adhesive elastic bandage for pressure bandaging. Otherwise, it is best to sew a few stitches on the external medical dressing to prevent it from loosening in the short term.
7. There are generally no obvious abnormalities after surgery. If the bandage is too tight, urination will be difficult. If it is tied with an elastic bandage, you can ask the patient to loosen it voluntarily, and then wrap it slightly loosely. If it is sewn, you can cut off the tight one or two staple sutures.
8. If the area becomes wet or polluted within a week, the surgical site should be disinfected immediately and the surgical dressing should be replaced. After two days, it can be tied loosely. When taking a shower within a week, it can be put on with a large condom or protected with a plastic bag. The near side can be tied with a rubber band to prevent water leakage. After washing, remove the condom or plastic bag. After a week, the external medical dressing can be removed and showered. Afterwards, soak in dry water and treat the surgical site with iodophor disinfectant. From then on, the surgical site should be treated with iodine disinfectant several times a day. You can decide whether to wrap it or not according to your own factors.Disclaimer:
1. This article is sourced from the Internet. All content represents the author's personal views only and does not reflect the stance of this website. The author shall be solely responsible for the content.
2. Part of the content on this website is compiled from the Internet. This website shall not be liable for any civil disputes, administrative penalties, or other losses arising from improper reprinting or citation.
3. If there is any infringing content or inappropriate material, please contact us to remove it immediately. Contact us at:

